 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| TFS175D.doc version 1.4 29.05.2002 VI TELEFILTER Measurement condition Ambient temperature: 23 C Input power level: 0 dBm Terminating impedances at fc *: input: output: Filter specification TFS 175 D 1/5 570 // -5,4 pF 500 // -6,4 pF Characteristics Remark: Reference level for the relative attenuation arel of the TFS 175 D is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 175,400 MHz without tolerance. The given values for the relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data Insertion loss (Reference level) Nominal frequency Centre frequency 1 dB Passband Amplitude ripple in PB Relative Attenuation fN 5,0 MHz ....... fN fN + 10,0 MHz ....... fN + fN + 12,0 MHz ....... fN + fN + 75,0 MHz ....... fN + fN - 75,0 MHz ....... fN fN - 174,4MHz ....... fN ae fN fc PB p-p arel typ. Value 6 175,4 770 MHz MHz MHz GHz MHz MHz 50 53 60 60 65 70 60 dB dB dB dB dB dB ns MHz kHz dB max. Limit 8 dB 175,4 MHz fN 250 max. min. min. min. min. min. min. 1 30 50 55 50 55 50 kHz dB dB dB dB dB dB dB ns 10,0 12,0 75,0 1,0 10,0 75,0 Group delay variation in PB Time domain response ** 5 10 15 20 40 s s s s s max. 200 -62 -85 -85 -85 -95 - 0,036 - dBc dBc dBc dBc dBc min min min min min max. max 2 -30 -50 -70 -80 -90 20 30 dBc dBc dBc dBc dBc dBm***) V Input Power Level Voltage between any two terminals Temperature coefficient of frequency Tcf Operating temperature range Storage temperature range Out of band intermodulation results ppm/K -10 C .. + 85 C C dBm - 40 C.. + 125 max. -56 input signals at 176 and 176,6 MHz at 4 dBm *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) Values are relative to the centre of the main response lob ***) This power level is only allowed for short term operation, the max. input power for continuous operation is only max. 15 dBm generated: checked / approved: VI TELEFILTER Vectron International, Inc. Potsdamer Strae 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: vti@vtinh.com E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS175D.doc version 1.4 29.05.2002 VI TELEFILTER Filter specification TFS 175 D 2/5 Construction and Pin Connection (All dimensions in mm) 9,1 - 0,1 + 0,2 4,8 - 0,1 TFS 175D P22 1 2 Date code M N P ... + 0,2 year + week 2000 2001 2002 60 1 0,8 0,2 5,08 0,2 7,01 +/- 0,2 1 2 3 4 5 6 7 8 9 10 Ground Ground Ground Output Output Ground Ground Ground Input Input 200 matching circuit: LB-IN C1 L2 2,54 0,1 2,8 0,2 1 5 LB-OUT L1 SAW 10 6 C3 1:4 C2 L3 4:1 2,3,4,7,8,9 VI TELEFILTER Vectron International, Inc. Potsdamer Strae 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: vti@vtinh.com E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS175D.doc version 1.4 29.05.2002 VI TELEFILTER Stability Characteristics Filter specification TFS 175 D 3/5 After the following tests the filter shall meet the whole specification: 1. Shock: 2. Vibration: 3. Change of temperature: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 -55 C to 125C / 30 min. each / 10 cycles DIN IEC 68 part 2 - 14 Test N 4. Resistance to solder heat (reflow): reflow possible: twice max.; for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: DIN IEC 286 - 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer mm Tape (all dimensions in mm) W Po Do E F : : : : : 16 4 0,3 0,1 Do Po EMBOSSED CARRIER TAPE 3000 min 300 mm min 500 mm min 300 P2 1,5 + 0,1 1,75 0,1 7,5 0,1 0,60 2 8 1,5 9,70 13,5 0,1 0,1 0,1 0,1 0,1 COVER TAPE P1 CT Bo Ao D1 E G (min) : P2 : P1 : D1(min) : Ao Bo CT : : : F W G 5,30 W2 Reel (all dimensions in mm): A : 330 16,40 +2,0 22,4 50 13,0 0,5/-0.2 A C N W1 : W2 (max) : N (min) C : : W1 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right. VI TELEFILTER Vectron International, Inc. Potsdamer Strae 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: vti@vtinh.com E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS175D.doc version 1.4 29.05.2002 VI TELEFILTER Air reflow temperature conditions Filter specification TFS 175 D 4/5 1st and 2nd air reflow profile Name: Temperature: Time: pre-heating periods 150 C - 170 C 60 sec. - 90 sec. main-heating periods over 200 C 20 sec. - 25 sec. peak temperature 255 C 5 C Chip-mount air reflow profile 260 240 220 200 180 temperature / C 160 140 120 100 80 60 40 20 0 0 20 40 60 80 100 120 time / sec. 140 160 180 200 220 240 Table for temperature vs. time during the air reflow process Tolerance of temperatures: 5 C time / sec. 0 10 20 30 40 50 60 70 80 90 100 110 120 130 temperature / C 23 34 46 60 80 103 121 134 143 150 154 156 158 159 time / sec. 140 150 160 170 180 190 195 200 205 210 215 220 230 240 temperature / C 160 161 164 170 180 205 230 255 230 205 180 165 140 120 VI TELEFILTER Vectron International, Inc. Potsdamer Strae 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: vti@vtinh.com E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. TFS175D.doc version 1.4 29.05.2002 VI TELEFILTER History Version Reason of Changes Filter specification TFS 175 D 5/5 Name Date 1.0 1.1 1.2 Generation of "Development specification" according to customer requirements - change of package - max. insertion loss : 8.5 dB - terminating impedance added - typical values added - matching configuration added - change of package - changing relative attenuation - terminating impedance changed - intermodulation added - decreasing insertion loss - extending storage temperature range Steiner Pfeiffer Pfeiffer 15.08.2001 30.08.2001 14.01.2002 1.3 Pfeiffer 10.04.2002 1.4 Pfeiffer 29.05.2002 VI TELEFILTER Vectron International, Inc. Potsdamer Strae 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: vti@vtinh.com E-Mail: tft@telefilter.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. |
Price & Availability of TFS175D
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |